United Kingdom version. Opens in metres with UK band presets from the RSGB band plans (40 m ends at 7.2 MHz, 2 m at 146 MHz, plus the 4 m band), not the wider US allocations. US version
Antenna Length Calculator (UK Bands)
Cut lengths in metres for UK bands: 80 m to 3.8 MHz, 40 m to 7.2 MHz, the 4 m band at 70 MHz, 2 m around 145.500 and 70 cm, with coax stub lengths.
The interactive tool loads here when JavaScript runs.
About this toolWhat is the Antenna Length Calculator?
British amateurs work to an ITU Region 1 allocation, and several bands are narrower than in North America. The RSGB HF plan gives 80 m as 3.500 to 3.800 MHz and 40 m as 7.000 to 7.200 MHz, and the 2 m band stops at 146.0 MHz. A US preset such as 146 MHz sits right on the UK band edge, so this version swaps the preset buttons for UK frequencies and shows lengths in metres.
The default is the middle of the UK 40 m band. At 7.1 MHz a half-wave dipole with the usual end-effect factor of 0.95 comes out at 20.06 m overall, or two legs of 10.03 m. In a typical suburban garden that often means an inverted V or drooping ends, so the loop and quarter-wave rows help you compare what fits.
The UK also has a band most of the world lacks: 4 m, 70.0 to 70.5 MHz, held on a secondary basis. Its preset at 70.2 MHz sits in the narrowband section where the RSGB says most CW and SSB activity is found.
- Half-wave dipole with per-leg length, quarter-wave, 5/8-wave and full-wave loop
- Adjustable end-effect factor and the 468/f, 234/f, 585/f and 1005/f rules for comparison
- Velocity factor presets for coax, twin-lead and ladder line with 1/4, 1/2 and 1 λ sections
- Feet and inches or metres, band presets from 80 m to 2.4 GHz for the US and Canada, the UK or Australia
- Dipole length to resonant frequency
- Runs in your browser, shareable link
Updated
How to use the Antenna Length Calculator
- Keep "Band presets for" on United Kingdom and tap a band, or type the exact frequency you intend to use.
- Leave the end-effect factor at 0.95 for bare copper wire; drop it towards 0.93 for PVC-covered wire.
- Pick your coax from the velocity factor list if you need a quarter-wave stub or a matching section.
- Cut each leg slightly longer than shown, hang the antenna at its working height and trim both ends equally while watching the SWR.
Worked examples
40 m dipole for the UK band
Input
7.1 MHz, K 0.95
Output
20.06 m overall, 10.03 m per leg
Half a free-space wavelength at 7.1 MHz is 21.11 m; the end effect takes about a metre off. The UK band is only 200 kHz wide, so one cut at 7.1 MHz covers it with a tuner or a little trimming.
80 m dipole at 3.7 MHz
Input
3.7 MHz, K 0.95
Output
38.49 m overall, 19.24 m per leg
Few UK gardens take 38.5 m in a straight line. The same wire as an inverted V or with dog-legged ends needs to be a few percent shorter, so cut it long and trim.
4 m quarter-wave vertical
Input
70.2 MHz, K 0.95
Output
Radiator 1.014 m; full dipole 2.03 m
About a metre of rod or tube makes a 4 m ground plane, which is why the band suits a simple home-made antenna. Radials are cut to the same length or slightly longer.
2 m ground plane and coax stub
Input
145.5 MHz, RG-58 (VF 0.66)
Output
Radiator 48.9 cm; quarter-wave coax stub 34.0 cm
145.500 MHz is the FM calling channel in the RSGB 2 m plan. A quarter-wave of RG-58 is only 66% of the free-space length because the signal travels slower in the cable.
70 cm quarter-wave whip
Input
433.5 MHz, K 0.95
Output
16.4 cm
At UHF each millimetre counts, so cut the whip a centimetre long and file it back while checking the SWR on the radio.
Background and insight
The wavelength in free space is λ = c ÷ f, with c = 299,792,458 m/s. At 14.2 MHz that is 21.11 m, so half a wavelength is 10.56 m or 34.6 ft. A dipole cut to that length resonates lower than 14.2 MHz, because the current does not drop to zero exactly at the wire ends and the ends add capacitance. Shortening the wire by about 5% compensates. Half a free-space wavelength in feet is 491.8 ÷ f(MHz), and 0.95 of it is 467.2 ÷ f, which the ARRL Antenna Book and every licensing manual round to 468 ÷ f. The quarter-wave rule 234 ÷ f and the 5/8-wave figure of about 585 ÷ f follow the same way.
A closed loop has no ends, so the end effect works the other way and a full-wave loop resonates a few percent longer than one wavelength. The ARRL figure is 1005 ÷ f(MHz) feet, about 1.02 λ, which the calculator uses for the loop row. The end-effect factor depends on the ratio of length to wire diameter: thin HF wire is close to 0.95 to 0.97, insulated wire a little lower because the insulation slows the wave, and fat VHF tubing lower still. That is why every formula gives a starting length to be trimmed, not a final one.
Inside a transmission line the wave travels slower than in air, by the velocity factor (VF). Solid polyethylene coax such as RG-58 and RG-213 has a VF of about 0.66, foam coax 0.78 to 0.85 (LMR-400 is 0.85), 300 Ω twin-lead about 0.80, 450 Ω window line about 0.91 and open-wire line about 0.97. A quarter-wave matching section or stub cut from coax is therefore only 0.66 of the free-space quarter wave. Velocity factor applies to feedline sections, not to the radiating wire.
Common use cases
Amateur radio
Cut dipoles, inverted Vs, ground planes and loops for HF, VHF and UHF bands.
CB and marine VHF
Size a quarter-wave or 5/8-wave whip for 27 MHz or 156.8 MHz.
IoT and RF modules
Make a quick wire antenna for 433 MHz, 868 MHz or 915 MHz LoRa and ISM radios.
Receiving antennas
Build an FM broadcast, ADS-B (1090 MHz) or weather-satellite antenna from wire or rod.
Tips and limitations
- The UK 2 m band runs from 144.0 to 146.0 MHz. Cut for the middle of the part you use (145.5 MHz for FM) rather than for a US figure near 146 MHz.
- Use the 468 rule in metres as 142.6 ÷ f(MHz) for a half-wave dipole; it gives the same starting length as the 0.95 end-effect factor.
- Check RSGB band plan updates each year. They set where modes and calling channels sit inside the bands your Ofcom licence allows.
- PVC-insulated wire from a DIY shop resonates lower than bare copper of the same length. Start with K nearer 0.93 to 0.95.
Sources and further reading
- HF bands, Radio Society of Great Britain. UK band edges: 80 m 3.500 to 3.800 MHz, 40 m 7.000 to 7.200 MHz, 20 m, 15 m and 10 m.
- 70MHz band, Radio Society of Great Britain. The UK 4 m band, 70.0 to 70.5 MHz, its secondary status and sub-bands.
- 144MHz band, Radio Society of Great Britain. 2 m runs from 144.0 to 146.0 MHz; FM calling on 145.500 MHz.
- The Wireless Telegraphy (Exemption and Amendment) (Amendment) Regulations 2014, legislation.gov.uk. Regulation 10: licence exemption for CB equipment complying with IR 2027.2 (AM, SSB and DSB).
- ARRL Antenna Book, American Radio Relay League. The 468, 234 and 1005 rules of thumb.
Frequently asked questions
What are the UK band edges for 80 m and 40 m?
The RSGB HF band plan lists 80 m as 3.500 to 3.800 MHz and 40 m as 7.000 to 7.200 MHz. Both are narrower than the Region 2 allocations used in the US and Canada, so cut UK antennas for the middle of these ranges.
How long is a 40 m dipole in metres?
About 20.06 m overall at 7.1 MHz, made from two legs of 10.03 m, using an end-effect factor of 0.95. Insulated wire and an inverted-V shape both make the finished length a little shorter.
How long is an antenna for the 4 m band?
At 70.2 MHz a quarter-wave vertical is about 1.01 m and a half-wave dipole about 2.03 m. The UK 4 m band runs from 70.0 to 70.5 MHz on a secondary basis, so stations must not cause interference to other services.
What length should a 2 m antenna be for 145.500 MHz?
A quarter-wave radiator is about 48.9 cm and a half-wave dipole about 97.9 cm. 145.500 MHz is the FM calling channel in the RSGB plan, inside the UK 2 m band of 144.0 to 146.0 MHz.
Do I need a licence for a 27 MHz CB antenna in the UK?
No licence is needed to use CB equipment that meets Ofcom's interface requirements. A 2014 amendment to the Wireless Telegraphy exemption regulations added AM, SSB and DSB CB sets complying with IR 2027.2. A quarter-wave whip for 27.185 MHz is about 2.62 m.
Can I use the 468 formula in metres?
Yes: 468 feet is 142.6 m, so a half-wave dipole is about 142.6 ÷ f(MHz) metres. At 7.1 MHz that is 20.09 m against the 20.06 m from the end-effect factor, a difference you trim out anyway.
Is there an in-depth guide to the Antenna Length Calculator?
Yes. “Dipole Antenna Length: Where 468/f Comes From and When to Trust It” covers the background, how it works, common pitfalls and worked examples. Read the full guide.
Related Tools You May Like
Free, in-browser tools that pair well with this one.