United Kingdom version. Gas in kWh from your bill, oil in litres, price-cap rates for October to December 2026, the £7,500 Boiler Upgrade Scheme grant and the DESNZ 2026 grid factor, in pounds. US version
Heat Pump Savings Calculator (UK)
Compare a year of heating with an air source heat pump against a gas or oil boiler, at price-cap rates or a heat pump tariff, after the £7,500 Boiler Upgrade Scheme.
The interactive tool loads here when JavaScript runs.
About this toolWhat is the Heat Pump Savings Calculator?
Whether a heat pump saves money in the UK comes down to the ratio of electricity to gas prices. On the price cap for October to December 2026, electricity is 26.32p per kWh and gas 7.97p, a ratio of 3.3. A heat pump with a seasonal efficiency (SCOP) of 3 turns each kWh of electricity into three of heat, so on those flat rates it only just beats an 85% efficient gas boiler. A heat pump tariff, or a better installation, changes the answer.
Start from the gas kWh on your annual statement, the part used for heating and hot water. The tool works out the heat your home needs (gas kWh times boiler efficiency), the electricity a heat pump would use for that heat, and both costs and emissions.
In England and Wales the Boiler Upgrade Scheme pays £7,500 off an air source or ground source heat pump. Enter it as the incentive and the payback uses the cost after the grant.
- Gas, oil, propane and electric resistance baselines
- Heat demand from fuel bills or a known heat load
- Seasonal COP or HSPF2 input with backup heat share
- Payback, break-even prices and cost per kWh of heat
- CO₂e comparison and a COP sensitivity table
Updated
How to use the Heat Pump Savings Calculator
- Choose your current fuel. Typical defaults for unit, price and efficiency fill in and can be changed.
- Enter how much fuel you use for heating a year (winter bills minus summer use for gas) or, if you know it, the heat load in kWh.
- Enter the heat pump's seasonal COP, or switch to HSPF2 and enter the rating, plus the share of heat from backup strips.
- Enter your electricity price, the installed cost and any rebates, and pick your grid region for CO₂.
- Read the yearly costs, saving, payback, break-even prices and the COP sensitivity table.
Worked examples
Gas boiler, flat price-cap rates
Input
11,500 kWh gas, 85% boiler, 7.97p gas, SCOP 3.0, 26.32p electricity; £13,000 installed less £7,500 grant
Output
Gas £917 a year, heat pump £858; saving £59 a year; CO2e falls from 2.08 t to 0.43 t
The house needs 9,775 kWh of heat. The heat pump uses 3,258 kWh. The two cost about the same at these rates: the heat pump stays cheaper only while electricity is below 28.1p per kWh at this gas price.
Same house on a heat pump tariff
Input
SCOP 3.5 from a well-designed system, average 15p per kWh on a heat pump tariff
Output
Heat pump £419 a year; saving £498; payback on the £5,500 net cost in 11.1 years
A better SCOP and a cheaper rate together turn a break-even into a real saving. Ask installers for the design SCOP at your flow temperature, not the best-case figure.
Off-gas home on kerosene
Input
2,000 litres a year at 65p, 85% boiler, SCOP 3.0, 26.32p; £14,000 less £9,000 (BUS plus the £1,500 oil and LPG top-up)
Output
Oil £1,300 a year, heat pump £1,599: £299 a year more; CO2e from 5.41 t to 0.80 t
At this oil price the running cost does not fall at flat electricity rates, but emissions drop by 85%. On a cheaper heat pump tariff the comparison swings the other way.
Background and insight
The useful heat delivered by your current system is fuel used x energy per unit x efficiency. Energy contents come from the EIA: a therm is 100,000 Btu (29.31 kWh), a gallon of heating oil 138,500 Btu (40.59 kWh), a gallon of propane 91,452 Btu (26.80 kWh), and natural gas averages 1,036 Btu per cubic foot. Efficiency is the AFUE on the furnace or boiler label: about 80% for a standard gas furnace, 90% to 98% for condensing models, and 100% for electric resistance.
A heat pump moves heat rather than making it, so it delivers more heat than the electricity it uses. The ratio over a heating season is the seasonal coefficient of performance (SCOP). US ratings are given as HSPF2 in Btu of heat per watt-hour of electricity; dividing by 3.412 converts it to an average COP, so HSPF2 8.1 is about 2.4. HSPF2 is calculated for a moderate climate (DOE region IV), and real seasonal COP is lower in very cold places and higher in mild ones. On the coldest days many systems use electric resistance backup strips, which run at COP 1; the backup share setting accounts for that.
Payback is the net installed cost divided by the yearly saving. Federal incentives changed in 2025: the One Big Beautiful Bill Act ended the section 25C energy efficient home improvement credit for property placed in service after 31 December 2025, so the incentives field defaults to zero. Many states and utilities still offer rebates. CO₂ uses EPA Emission Factors Hub 2025 factors for the fuels and your eGRID region's rate for electricity.
Common use cases
Deciding on a heat pump
Get a running-cost answer from your own bills before talking to installers.
Replacing an old furnace or boiler
Compare a like-for-like replacement with switching fuels when the old system fails.
Checking an installer's savings claim
Put the quoted COP and price in and see whether the promised savings hold up.
Comparing fuels
See the cost per kWh of delivered heat for gas, oil, propane and electricity side by side.
Tips and limitations
- Deduct summer gas use (hot water and cooking) only if you are not replacing the hot water system too; a heat pump usually heats the cylinder as well.
- Boiler efficiency in real homes is often 80 to 90%; older non-condensing boilers can be lower, which favours the heat pump.
- Get the design flow temperature and SCOP from your MCS installer's heat loss survey and use those figures here.
Sources and further reading
- Boiler Upgrade Scheme: what you can get, GOV.UK. Grant amounts and the oil and LPG top-up.
- Get energy price cap standing charges and unit rates by region, Ofgem. Gas 7.97p and electricity 26.32p per kWh; standing charges.
- Greenhouse gas reporting: conversion factors 2026, Department for Energy Security and Net Zero. UK grid electricity factor.
Frequently asked questions
How much is the Boiler Upgrade Scheme grant?
GOV.UK lists £7,500 for an air source or ground source heat pump, £5,000 for a biomass boiler and £2,500 for an air-to-air heat pump. Until March 2027 there is an extra £1,500 for air source or ground source heat pumps in homes heated by oil or LPG with no mains gas connection. The scheme is open in England and Wales.
Will a heat pump be cheaper to run than my gas boiler?
Divide your electricity rate by your gas rate. If the result is below the heat pump's SCOP divided by the boiler efficiency (about 3.5 for SCOP 3 and an 85% boiler), the heat pump is cheaper per kWh of heat. On October to December 2026 cap rates the ratio is 3.3, so it is just cheaper; a heat pump tariff makes the gap much wider.
What SCOP should I use?
Use the figure from your installer's design for your flow temperature. Well-designed systems running at low flow temperatures often reach 3 to 4; a system run hot through small radiators will be lower.
Can I get a heat pump grant in Scotland or Northern Ireland?
Not through the Boiler Upgrade Scheme, which covers England and Wales. GOV.UK points people in Scotland to Home Energy Scotland. Northern Ireland's Boiler Replacement Scheme is closed; check nidirect for current energy grants.
How much CO2 does a heat pump save in the UK?
With the DESNZ 2026 factors, 11,500 kWh of gas emits about 2.08 t CO2e and the heat pump's 3,258 kWh of electricity about 0.43 t, a cut of almost 80%. The saving grows as the grid gets cleaner.
Should I count the standing charge?
If you remove gas altogether you stop paying the gas standing charge, 29.68p a day on the October to December 2026 cap, about £108 a year. The tool compares unit costs only, so add that saving yourself if you plan to cap the gas supply.
Is there an in-depth guide to the Heat Pump Savings Calculator?
Yes. “Heat Pump vs Gas Furnace: Running Costs and Payback” covers the background, how it works, common pitfalls and worked examples. Read the full guide.
Related Tools You May Like
Free, in-browser tools that pair well with this one.