Hiking Time Calculator
Estimate walking time from distance and ascent with Naismith's rule, then correct for the descent the way Langmuir does. Shows the working.
The interactive tool loads here when JavaScript runs.
About this toolWhat is the Hiking Time Calculator?
Walking time is not set by distance alone. A flat ten kilometres and a ten kilometre route with six hundred metres of climbing are the same line on a map and a very different afternoon, which is why estimates based on distance alone run late on exactly the days it matters.
This calculator uses the rule the hills have used since 1892. Naismith allowed one hour for every three miles of map distance, then added an hour for every two thousand feet of ascent. In metric that is five kilometres an hour on the flat plus a minute for every ten metres climbed. Langmuir later added what to do with the descent, which Naismith ignored entirely.
- Naismith's rule and Langmuir's descent correction, both named and sourced on the page.
- The full working for your own numbers, line by line, so the estimate can be checked rather than trusted.
- A chart and table of the same walk across a range of base speeds, because the single number hides how much pace matters.
- Metric or imperial entry, converted internally so the arithmetic stays in one unit system.
- Inputs live in the link, so a plan can be shared or reopened exactly as it was.
Updated
How to use the Hiking Time Calculator
- Measure the map distance and the total ascent for your route. Total ascent means every climb added up, not the difference between the car park and the summit, which is why a switchback ridge takes far longer than its height suggests.
- Set the base speed. Naismith assumed 5 km/h; Langmuir uses 4 km/h off paths, and a group with mixed fitness is usually slower still.
- Enter the descent and say how steep it is. Gentle means roughly 5 to 12 degrees and saves time; steep means over 12 degrees and costs it. Choose no correction if you would rather not bank the saving.
- Add the time you expect to spend stopped. Lunch, photographs and regrouping are not rounding errors on a long day.
- Read the total, then set your turnaround time from it and from when the light actually goes, which is earlier than sunset in a valley or under cloud.
Background and insight
Naismith published the rule in the Scottish Mountaineering Club Journal in 1892 as a single sentence about his own day on the hill, and it has survived because it is close enough and can be done in your head. Langmuir's Mountaincraft and Leadership, the handbook of the Mountain Leader Training Boards, added the corrections that mountain leaders are taught: take ten minutes off per three hundred metres of gentle descent, and put ten minutes back on per three hundred metres of steep descent, because steep ground down is slower than flat ground.
The honest caveat is that the gentle-descent saving is the most disputed part of the rule, so the calculator asks about the descent rather than applying the correction silently. Empirical work supports the ascent allowance: Scarf's analysis of fell running records in the Journal of Sports Sciences found the distance to climb equivalence close to Naismith's, recommending roughly 1:8 for men and 1:10 for women.
Treat any answer here as a floor rather than a prediction. The rule assumes a fit party, good conditions and no stops, so rough ground, a heavy pack, poor visibility, deep snow or a group all push the real figure above it.
Common use cases
Planning a hill day
Turning a distance and an ascent into a finish time you can plan daylight around.
Setting a turnaround time
Working backwards from dusk to the time you have to start down, whatever you have reached.
Comparing two routes
The shorter route with more climbing is often the slower one, and the numbers show it.
Leading a group
Re-running the estimate at a slower base speed, which is what the group will actually walk at.
Tips and limitations
- Total ascent is the number that matters, not the summit height. A route over three tops climbs far more than the map's highest contour suggests.
- Add time rather than speed for a heavy pack. Naismith's base speed assumes a day sack, not a full winter load.
- In winter, expect the estimate to be optimistic. Short daylight, snow underfoot and extra layers to manage all push a day well past the rule.
- If the estimate and the available daylight are close, the route is too long. Plan the shorter option rather than the faster walk.
- Re-run it with the slowest plausible speed before you commit. The gap between 5 km/h and 3.5 km/h on a long day is often more than an hour.
Sources and further reading
- Route choice in mountain navigation, Naismith's rule, and the equivalence of distance and climb, Journal of Sports Sciences (Scarf, 2007)
- Naismith's rule, with Langmuir's corrections and their sources, Wikipedia
- Mountain Rescue England and Wales, Mountain Rescue England and Wales
Frequently asked questions
What is Naismith's rule?
A rule of thumb from 1892: allow one hour for every three miles of map distance, and add one hour for every two thousand feet of ascent. In metric that is five kilometres an hour plus one minute per ten metres climbed. It is deliberately simple so it can be done on the hill without a calculator.
Does it account for going down?
Naismith did not. Langmuir added the correction that mountain leaders are taught: subtract ten minutes per three hundred metres of gentle descent, around five to twelve degrees, and add ten minutes per three hundred metres of steep descent above twelve degrees. The calculator lets you turn that off, because the gentle-descent saving is the part of the rule most often questioned.
Why is my walk slower than the estimate?
Because the rule describes a fit party moving continuously in good conditions. Rough or boggy ground, a heavy pack, scrambling, poor visibility, snow, heat and group size all add time, and none of them are in the formula. The estimate is a floor.
Should I use 4 or 5 km/h as the base speed?
Five is Naismith's original figure and suits good paths. Four is what Langmuir uses off paths and is the safer default for open hillside, for a group, or for anyone carrying a full pack. If in doubt, run both and plan on the slower one.
What counts as total ascent?
Every metre of climbing added together, including the re-ascents between tops and after descents. It is not the difference between your start height and the summit, which is why a ridge with several dips takes much longer than its highest point suggests.
Is the rule accurate?
For the ascent allowance it holds up well. An analysis of fell running records published in the Journal of Sports Sciences found an equivalence between distance and climb close to Naismith's original, around 1:8 for men and 1:10 for women. The descent corrections are less settled, which is why they are optional here.
Is there an in-depth guide to the Hiking Time Calculator?
Yes. “Why Checklists Work, and How to Use One Properly” covers the background, how it works, common pitfalls and worked examples. Read the full guide.
Related Tools You May Like
Free, in-browser tools that pair well with this one.