Canada version. Kilometres per hour, Canadian tire spelling and a winter tire example, since many drivers switch sizes each season and Quebec requires winter tires from December 1 to March 15. US version

Gear Speed Calculator (Canada)

Engine rpm at 100 km/h and speed in every gear from gear ratios, final drive and tire size, plus what a narrower winter tire size does to your speedometer.

The interactive tool loads here when JavaScript runs.

About this tool

What is the Gear Speed Calculator?

Most Canadian drivers own two sets of tires, and many put the winter set on smaller wheels. Quebec requires winter tires on passenger vehicles from December 1 to March 15, and in the rest of the country seasonal changeovers are common. A different tire size changes the overall diameter, which changes rpm at highway speed and what the speedometer shows, so this version is set up to compare a summer and a winter size.

With a car on 225/45R17 summer tires, a six-speed gearbox and a 3.42 final drive, the engine turns 1,602 rpm at 100 km/h in sixth. A 205/55R16 winter tire, the usual one-size-smaller choice, is only 0.4% smaller, so the rpm and the speedometer barely move. Pick a taller 215/60R16 instead and the tire is 4.7% larger: the speedometer reads 100 km/h when you are doing about 104.7 km/h.

Enter your own gear ratios and final drive from the owner's manual, then switch the tire size to see the change in every gear. Speeds assume no slip and the unloaded tire size.

  • Tyre diameter from metric codes (P, LT and ZR included), flotation sizes or a typed diameter
  • Up to eight gear ratios plus final drive and redline
  • Speed per gear at any rpm and at redline, rpm at a cruise speed, rpm after each upshift
  • rpm versus speed chart for every gear with redline and cruise markers
  • km/h or mph, copy results and share link
Read the guide: Road Speed from RPM, Gear Ratio and Tire Size: The Formula

Updated

How to use the Gear Speed Calculator

  1. Choose km/h or mph, then enter the tyre size code or switch to diameter and type it in inches or millimetres.
  2. Enter each gear ratio; add or remove gears to match the gearbox (up to eight).
  3. Enter the final drive (axle or differential) ratio and the redline.
  4. Enter a cruise speed and an engine speed of interest.
  5. Read the table: speed at your rpm and at redline in each gear, rpm at the cruise speed, and rpm after each upshift. The chart shows the same thing graphically.

Worked examples

Summer 225/45R17 at 100 km/h

Input

Ratios 3.36, 2.07, 1.43, 1.00, 0.84, 0.56; final drive 3.42; 225/45R17; 100 km/h

Output

Sixth 1,602 rpm; fifth 2,403 rpm

A tall overdrive top gear keeps highway rpm low; fifth is the gear to look at for passing.

Winter 205/55R16 and 215/60R16

Input

Same car, tire 205/55R16, then 215/60R16

Output

205/55R16: 0.4% smaller, 1,608 rpm in sixth; 215/60R16: 4.7% larger, 1,529 rpm, true speed 104.7 km/h at an indicated 100

Stay close to the original overall diameter when choosing a winter size, or the speedometer and rpm figures shift with it.

Background and insight

The wheel turns at engine rpm divided by the overall ratio, which is the gear ratio times the final drive. Each turn moves the car one tyre circumference, π x diameter. So speed in km/h is wheel rpm x π x diameter (mm) x 60 / 1,000,000. In US units this reduces to the familiar mph = rpm x tyre diameter (in) / (gear x axle ratio x 336), where 336.13 is 63,360 inches per mile divided by 60π.

A metric tyre code gives the section width in millimetres, the aspect ratio as a percentage of that width, and the rim diameter in inches. Overall diameter is rim x 25.4 + 2 x width x aspect / 100 mm, so a 225/45R17 is 431.8 + 202.5 = 634.3 mm. That is the unloaded size. Under load the tyre flattens and rolls on a slightly smaller effective radius, and worn tread is smaller again, which is why makers publish revolutions per mile measured on a rolling tyre.

The rpm drop on an upshift is the shift rpm times the ratio of the next gear over the current one. Close-ratio gearboxes keep that drop small so the engine stays near peak power; wide ratios trade that for a tall top gear that keeps cruising rpm low.

Common use cases

  • Axle ratio and tyre swaps

    See how a different final drive or taller tyres change cruising rpm and the speed in each gear before buying parts.

  • Track and drag gearing

    Check the rpm drop between gears and whether a gear runs out before the end of a straight or the finish line.

  • Engine swaps

    Pair a new engine's redline and power band with the existing gearbox and axle.

  • Speedometer sanity checks

    Compare calculated road speed at a given rpm with what the speedometer shows after a tyre change.

Tips and limitations

  • Tire sizes and the approved alternatives for your vehicle are on the tire placard, usually on the driver's door jamb.
  • Quebec only counts tires with the mountain and snowflake pictogram, or studded tires, as winter tires under its rules.
  • Check the rpm at a steady 100 km/h on a flat road against the table; a large difference usually means a different final drive.

Sources and further reading

  1. Winter tires: winter preparation, Société de l'assurance automobile du Québec. Winter tires required from December 1 to March 15; pictogram requirement.
  2. Requirements for winter tires, Gouvernement du Québec

Frequently asked questions

Does a smaller winter tire change my speedometer?

Only if the overall diameter changes. A 205/55R16 replacing a 225/45R17 is within half a percent, so the change is negligible. A larger-diameter tire makes the speedometer read low.

Are winter tires mandatory in Canada?

Quebec requires them on vehicles registered there from December 1 to March 15. Elsewhere, check the rules of the province you drive in, which may apply only on certain highways or not at all.

What rpm should a car run at 100 km/h?

Depends on the gearing: many cars with six or more speeds run 1,600 to 2,500 rpm in top. Enter your gear ratios, final drive and tire size to get your figure.

How do I calculate tire diameter from the size?

Rim diameter in inches x 25.4 plus twice the sidewall height (width x aspect / 100). For 225/45R17 that is 431.8 + 2 x 101.25 = 634.3 mm.

Can I switch the calculator to mph?

Yes. The speed units toggle converts the cruise speed, which helps when checking a vehicle imported from the United States.

Is there an in-depth guide to the Gear Speed Calculator?

Yes. “Road Speed from RPM, Gear Ratio and Tire Size: The Formula” covers the background, how it works, common pitfalls and worked examples. Read the full guide.